Step 5: Connect an ethernet cable from the LAN port of the goCoax device.Īt this point, the ‘network traffic’ is going to be sent over the coax network. Step 3: Connect a new coax cable to the TV port of the goCoax adapter and connect the other end of the cable to your cable modem. Step 2: Connect the cable connected to the cable modem to the MOCA port on the goCoax. Step 1: Disconnect the coax cable from the cable modem. I have the cable modem in my office, which is connected via coax. For me, I have the local cable company provide Internet only and through coax. The setup was easy and will vary depending on your home network and internet access. The goCoax adapters come with the splitter built-in. If you are using another MoCA adapter that is not the goCoax one, you may need to purchase cable splitters. You will need at least 2 coax cables for this setup. My setup is based on having the goCoax adapters. Also, MoCA can support a maximum of 16 adapters on one network. Note You need at least 2 MoCA adapters for this work. I purchased 2 goCoax MoCA 2.5 Adapter for Ethernet Over Coax adapters to give it a shot. All of these are critical to a good streaming video or online gaming experience.Īfter watching this video and checking out a few diagrams like this one, diagram 1, I decided to give this a shot since I have an existing unused Coax network in my home. Because MoCA technology is wired, it also delivers a reliable, low-lag, and ultra-high-speed connection. In essence, MoCA creates a wired Internet home network without the headache of drilling holes or running wires. MoCA (stands for Multimedia over Coax Alliance) is a technology that uses the existing coaxial cables already in most people’s homes. I then proceeded to add the NETGEAR EX8000 repeater to the network to extend the network, and after a few days, the network latency and packet drops started again. I tried just using this device by itself for a few days, and the problems did not go away. This router also can add nodes to the network to create a mesh network using its AIMesh. I updated my router to This router has all kinds of benefits like three bands, so I could dedicate a separate band to my son’s office (his computer and Xbox). This led to attempt two to resolve the network latency and packet drops. I wanted to get an ethernet connection in my son’s office to reduce or eliminate the network latency and packet drops. There were packet drops, and the latency was spiking. This attempt worked for a bit except when I was on a video call, the wife was streaming, and the son was gaming. This combination had ‘FastLane3’ technology (Dedicated WiFi Link to the router to avoid halving bandwidth of extended WiFi signals and innovative antenna design for ultimate coverage). I already had a NETGEAR Nighthawk X4S WiFi Router (R7800), so I added a NETGEAR WiFi Mesh Range Extender (EX8000) to offload some of the wireless clients too. On the first attempt, I extended my wireless network with a network repeater. I currently don’t have any CAT5/6/7 wiring in my house, so I tried extending my wireless network a few different ways. All of these devices, plus the other 30 or so on, were taxing my router. These devices are typically streaming in some way, shape, or form. The main house TV, my work computer, my son’s computer or Xbox, and the daughter’s Fire Stick/YouTube. Since working from home, I have three to four machines that are constantly ‘on the internet’. At any given time, there are around forty devices connected to my home network. I have multiple Amazon Fire Sticks, computers, smart TVs, mobile phones, smart appliances, and so much more. There are so many devices that are connected to our home networks nowadays. Hard Wire your Home without Ethernet using MoCA
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |